Advertisement
Available languages
Available languages
1. Introduction
Congratulations on your new wood-burning stove. By now you have probably installed the stove already, and maybe
lit the stove for the first time as well. To most people, operating instructions are something you consult when every-
thing else fail - especially if you have had a wood-burning stove in your home for several years. In spite of this, we
still hope that you will take a little time to read these operating instructions, since the use of a wood-burning stove
is an individual matter, depending on which model you have. Before you can fully enjoy being the owner of a wood-
burning stove, you need to get to know it well. This is not difficult, however, it does take a little bit of patience. For
further information on heat, stoking, combustion problems and maintenance, please refer to Jydepejsen´s „Manual
for installation and stoking". Please also refer to the illustrations in the back.
2. Installation
Jydepejsen stoves are tested by specialist institutions and approved according to applicable legislative requirements.
Before final approval is granted, stoves have to successfully complete a variety of combustion tests. The stove te-
sted featured a top outlet. The wood used for the tests was birch, with a moisture content of 15–21%.
You must install your stove according to the required minimum distance to combustible materials. See also the boiler
plate on the stove for details.
If you have a model Cubic Wall/Cubic Corner/Cubic W200 you must hang up the stove using the
enclosed fitting. The hanging must not weaken the chimney construction. The anchoring must be
carried out in consultation with your dealer/chimney sweep.
Floor / foundation / wall
The stove must be installed/hanged on a non-combustible foundation/at a non-combustible wall - i.e. where a tile or
brick floor is non-existing, the stove must meet the demands for the distance to combustible material under/above/
beside the stove, according to applicable legislative requirements. Consult you dealer before installing the stove.
If you have a Cubic Wall/Cubic Corner/Cubic W200 the stove must be installed with the enclosed furnishings. The
installation must not weaken the chimney construction. The anhoring must be done in consultation with your dealer/
chimney sweep.
If you have a turnable Trend-line 2, note that the installation must be done as illustrated below, with regards to
combustible material.
Installation against a straight, combustible wall
In addition, it is important to check that the Vermiculite panels are correctly fitted in the combustion chamber.
The wood holder in the combustion chamber is not to be removed.
On some baffle plates you will find a metal band. This band is mounted for transport protection only, and should be
removed.
Installation in a corner agaist a combustible wall
Advertisement
