Selecting Display Mode - Sony Trimaster EL BVM-E250 Operation Manual

Operations

Selecting Display Mode

This monitor applies high-contrast to the picture and
reproduces accurate color by displaying the interlace
signal in progressive mode by the I/P conversion or the
PsF·progressive signal in progressive mode without the
I/P conversion.
You can select interlace display mode according to the
input signal or the object to evaluate the picture.
Interlace display mode: The picture is displayed in
interlace mode without I/P conversion processing. The
picture near the original quality of the input signal is
monitored.
Notes
1)
• When a 1080/24 P (PsF) or 1080/25P (PsF) input
signal is displayed in progressive mode, the frame rate
1)
for display is 72 Hz or 75 Hz to obtain flickerless
display.
• When the input signal is 1080/24
and 1080I is set in the 1080I/PsF menu of the Channel
Configuration menu, the frame rate for display is 48
Hz or 50 Hz.
• The luminance is reduced owing to the principle of
operation in the interlace display mode. However, on
this monitor the normal luminance is set by increasing
the value of gain. For this reason, in the interlace display
mode, the range of the contrast adjustment is different
from the normal level, and the luminance may be
reduced according to the setting of the contrast.
• The picture is not displayed in interlace mode in the
following cases:
– When Side by Side, Wipe, Butterfly or Blending is
set to On
– When Pixel Zoom is set to on
1
For selecting the interlace display mode, set Native
Scan (page 65) to On in the Function Setting menu or
by pressing the NATIVE SCAN button of the
controller.
1)
PsF or 1080/25PsF
1)
Chapter
2
Set Interlace to On in the Function Switch menu (page
65) of the Function Setting menu, or pressing the
2)
Interlace button on the controller.
iiFunction Switch
xxx
Aperture:
xxx
Mono:
xxx
Blue Only:
xxx
R Off:
xxx
G Off:
xxx
B Off:
xxx
Chroma Up:
xxx
Interlace:
For the input signal to display in frame mode and
interlace mode, see "Picture Frame Display" on
page 123.
1) Also compatible with a frame rate of 1/1.001.
2) Interlace is assigned to a function button of the controller in the Function
Key menu (page 82) of the Controller menu.
4
v
2/5
V
87
Selecting Display Mode