Sony Trimaster EL BVM-E250 Operation Manual page 64

Menu
HDMI/DP RGB
Post-Process Detection
Detection
Pixel Threshold
Signal Level
Zebra Pattern
Line
Modulation
3D Setting
Horopter Check
Left
Right
Capture
Load
Rename
64
Function Setting Menu
Function and operation ([
Upper Limit (upper limit)
G: 0000 to 4095 [3935] (12bit conversion value)
B: 0000 to 4095 [3935] (12bit conversion value)
R: 0000 to 4095 [3935] (12bit conversion value)
Lower Limit (lower limit)
G: 0000 to 4095 [0080] (12bit conversion value)
B: 0000 to 4095 [0080] (12bit conversion value)
R: 0000 to 4095 [0080] (12bit conversion value)
Sets the error detection setting for the signal after YCbCr is converted to RGB.
Sets whether or not to detect the error of the input signal ([Off] or On).
Sets the pixel number of the gamut error in the frame to notify the gamut error detection.
When the pixel number of the error is over the set pixel number, the detection is notified.
Set to 00000 to 65535. [00000]
Sets the upper and lower lines of the signal level.
The signal level to be set is black level 256 and white level 3760 in 12bit conversion value.
Upper Limit: 0000 to 4095 [3761]
Lower Limit: 0000 to 4095 [0255]
Sets the zebra pattern displayed by the gamut error detection.
Sets the direction of the pattern.
[Diagonal Type1]: Right descending
Diagonal Type2: Left descending
Sets the amplitude of the pattern display.
Set to 1 to 50. [16]
Sets the mode of Horopter Check of the 3D signal analyzing function.
This item can be selected when the BKM-250TG is installed, and is available for dual-stream
HD-SDI signal input.
Changes the display mode of the left and right 3D video signals.
Selects the display mode of the left signal.
[Normal]: Normal picture
Black: Displays a black signal (the video signal is not displayed).
Mono: Displays the video signal in monochrome mode.
Red: Displays only the red component of the video signal.
Blue: Displays only the blue component of the video signal.
Selects the display mode of the right signal.
[Normal]: Normal picture
Black: Displays a black signal (the video signal is not displayed).
Mono: Displays the video signal in monochrome mode.
Red: Displays only the red component of the video signal.
Blue: Displays only the blue component of the video signal.
Captures the still picture for the standard of the color evaluation (HD Frame Capture).
Note
Use the controller with software version 1.6 or higher to use the HD Frame Capture function.
Loads the captured picture from the "Memory Stick".
When the item is selected, you can select the file name to be loaded.
Changes a file name of the captured picture in the "Memory Stick".
When the item is selected, the file names are displayed.
When the file name is selected, you can change the file name (1 to 20 characters).
Existing file name: Enter the existing file name.
New Name: Enter a new file name.
Note
The "." must not be used as the first character.
]: factory setting)