Factory Reset; Hardware Installation; Connecting The Power Adapter - D-Link DI-304 User Manual

Hide thumbs Also See for DI-304:

Table of Contents

The DI-304 has a power jack, an uplink port, four RJ-45 ports, an ISDN port on the rear

panel, and a factory reset button. Please note that only the D-Link supplied power adapter

should be connected to the power jack.

1. Connect the power adapter to the electrical outlet in the wall and to the power jack on

the rear panel of the router.

2. The Act LED should be blinking once every 2 seconds.

♦ POWER — This socket is an 18 volt, 750mA power input jack. If the

power adapter included with the router has been lost or misplaced, please

ensure that the replacement adapter meets both the voltage and amperage

requirements.

♦ ETHERNET – The Ethernet ports function as a normal, dual speed NWay

Ethernet switch.

♦ Uplink – This port is used to connect the router to another

switch or hub using a straight-through twisted-pair cable. When

the Uplink port is used, Port 1x is unavailable.

♦ Ports 1x to 4x – These four ports can be used to connect end-

stations to the router using straight-through cables.

♦ ISDN – This socket is used to connect the ISDN line to either an NT-1 or

directly to the ISDN wall jack, depending on the type of service delivered by

your phone company.

♦ Factory Reset :

Press and hold the button. Then switch on your DI-304.

The Status LED flashes.

To reset the DI-304 to the factory settings: Press and hold the button for 5

seconds when the unit is switched on. The Status LED will flash more

quickly – at this moment, release the button and the router is reset to its

factory settings.

DI-304/DI-304M ISDN Remote Router

Table of Contents