Sony STR-DH700 Operating Instructions Manual page 63

Tuni'ngJ~to
a station directly-
(Direct Tuning),'
Enter the frequency of a station directly by
using the numeric buttons.
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Press D.TUNING.
3
Press the numeric buttons to
enter the frequency.
Example I: FM 102.50 MHz
Select 1 • 0 • 2 • 5 • 0
Example 2: AM 1,350 kHz
Select 1 • 3 • 5 • 0
If you have tuned in an AM station, adjust
the direction of the AM loop antenna
(aerial) for optimum reception.
4
Press ENTER.
You can also use MEMORYIENTER on
the receiver.
If
you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
Chang,-ng _he AM:: tuning seale
. 1
~ . . ,.J • ':::C. ~- .'"-- ~' ::i
(Models of area code U, CA only)
You can change the AM tuning scale to either
9 kHz or 10kHz using the buttons on the
receiver.
1/(9
TUNING MODE
1
Press
I/O
to turn off the
receiver.
2
While holding down TUNING
MODE, press I/O.
3
Change the current AM tuning
scale to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
Note
All preset stations will be erased when you change
the tuning scale.
63 US
-