Datalogic Matrix 300 Reference Manual page 85

TYPICAL LAYOUTS
The same configuration can be made to a Host using a TCP/IP Ethernet interface. In this
case the Master is connected to a CBX500 with BM200/210 Host Interface Module installed.
The TCP/IP Ethernet, auxiliary, and ID-NET™ interfaces are connected as shown in the
figure below.
Power
CBX500
1
Figure 65 – ID-NET™ M/S Synchronized Layout with BM200/210 TCP/IP Ethernet Interface to Host
Alternatively, the Master reader can communicate to the Host as a Slave node on a Fieldbus
network. This requires using an accessory Fieldbus interface board installed inside the
CBX500 connection box.
System configuration can be accomplished through the Auxiliary interface of each individual
reader (internal CBX500 9-pin connector) using the VisiSet™ configuration program or Host
Mode programming. See par. 2.3.1 for details.
Power
Master
1
Host
3
Slave#1
Master
2
Host
3
Slave#1
2
Figure 66 – ID-NET™ Fieldbus M/S Synchronized Layout

BM2x0 TCP/IP Ethernet Interface

External Trigger

ID-NET™ (up to 16 devices - practical limit)

Fieldbus Interface

External Trigger (for One Shot or Phase Mode)

ID-NET™ (up to 16 devices - practical limit)
5
Slave#n
Slave#n
73