Hot-Plug Drive Guidelines - HP ProLiant DL160 Gen8 User Manual

Remove the access panel (on page 19).
5.
Remove the processor air baffle (on page 19).
6.
Open the DIMM slot latches.
7.
Install the DIMM.
8.
Install the processor air baffle (on page 20).
9.
Install the access panel (on page 19).
10.
Slide the server into the rack.
11.
Connect each power cord to the server.
12.
Connect each power cord to the power source.
13.
Power up the server (on page 17).
14.
If removed, install the rack bezel (on page 58).
15.
If you are installing DIMMs in online spare or lock-step configuration, configure this mode in RBSU
ROM-Based Setup

Hot-plug drive guidelines

When adding drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
If only one drive is used, install it in the bay with the lowest device number.
•
Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Utility" on page 74).
("HP
Hardware options installation 43