HP ProLiant DL160 Gen8 User Manual page 48

Install the drive into the drive bay, and then using the T-10 screw from this kit, secure the drive.
b.
Connect the cable from the rear of the drive to the SATA DVD-ROM drive connector on the system
c.
board. Use cable (HP part number 663771-001 to connect to the drive. Connect the blue and black
end of the cable to the optical drive, connect the longer blue end to the SATA connector on the
system board and the short black cable to the power connector.
Install the PCI riser cage (on page 21).
11.
Install the processor air baffle.
12.
Install the access panel (on page 19).
13.
Slide the server into the rack.
14.
Connect each power cord to the server.
15.
Connect each power cord to the power source.
16.
Power up the server (on page 17).
17.
If removed, install the rack bezel (on page 58).
18.
Hardware options installation 48