FLIR T420-NIST User Manual page 66

17 – Working with fusion
Procedure
Follow this procedure to set up a fusion type:
56
netzerotools.com
1 Push the Mode button to select one of the following:
Thermal fusion
■
Picture-in-Picture
■
2 Push the A/M button to select one of the following:
Above.
■
Below
■
Interval
■
3 (This step applies to Thermal fusion.)
Do one or more of the following:
If you chose Above or Below, move the joystick up or down to adjust
■
the temperature level. The temperature level that you set will be the level
beyond which the infrared image will be displayed as a visual photo.
If you chose Interval, do one or more of the following:
■
Push the joystick up/down to move the interval up/down.
■
Push the joystick left/right to increase/decrease the interval.
■
The temperature levels that you set will be the level beyond which the
infrared image will be displayed as a visual photo.
4 (This step applies to Picture-in-Picture.)
Do one or more of the following:
If you chose Above or Below, move the joystick up or down to adjust
■
the temperature level in the infrared portion of the image.
If you chose Interval, do one or more of the following:
■
Push the joystick up/down to move the temperature interval up/down
■
in the infrared portion of the image.
Push the joystick left/right to increase/decrease the temperature inter-
■
val in the infrared portion of the image.
5 To deactivate Fusion, push the Mode button to select Thermal camera.
netzerotools.com
.
.
Publ. No. T559772 Rev. a593 – ENGLISH (EN) – March 16, 2012