Yamaha RS90NL Suplementary Service Manual page 78

a
1
3
2
2
1
3
a
REAR SUSPENSION
Control rod (RS90N/RS90NR/RS90RS/RS90MS)
1. Adjust:
• Control rod stroke a
CAUTION:
Make sure the adjusting bolt ends are set at the
same position on each side.
Adjustment steps:
• Loosen the locknut 1.
• Turn the adjusting nut 2 in or out to adjust the
control rod stroke.
Adjusting
position
Effect Increase
weight
transfer
Standard
WARNING
Never adjust the control rods beyond the maxi-
mum range indicated on the rods with red paint
3.
• While holding the adjusting bolt securely,
tighten the locknut 1.
Locknut:
25 Nm (2.5 m · kg, 18 ft · lb)
Control rod (RS90GT)
1. Adjust:
• Control rod stroke a
Adjustment steps:
• Loosen the locknut 1.
• Turn the control rod adjuster 2 in direction b
or c to adjust the control rod stroke.
Adjusting
Minimum
position
Effect Increase
weight
transfer
Standard Second mark to the left of MAX
30
INSP
ADJ
1 2 3
Decrease
← →
weight
transfer
2
Standard Maximum
Decrease
← →
weight
transfer