Yamaha RS90NL Suplementary Service Manual page 221

Parts to be tightened
Control rod shaft and sliding frame
Rear pivot arm bracket and sliding frame
Rear axle
Set bolt (front axle)
Speed sensor
Bearing holder
Gear unit (speed sensor)
*: ESSO beacon 325 grease or Aeroshell grease #7A
NOTE:
Tightening steps:
1. Tighten the bolt to a torque at 120 Nm (12.0 m · kg, 85 ft · lb).
2. Loosen the bolt completely.
3. Retighten the bolt to a torque of 60 Nm (6.0 m · kg, 43 ft · lb).
TIGHTENING TORQUE
Tightening torque
Nm m · kg ft · lb
72 7.2 52 (RS90N/RS90NR/RS90RS/
RS90MS)
72 7.2 52 (RS90GT) Apply LOCTITE
75 7.5 54
9 0.9 6.5 Apply LOCTITE
20 2.0 14
20 2.0 14
40 4.0 29
112
SPEC
Remarks
®
®