Yamaha XV19SX(C) Service Manual page 97

1. Front right turn signal/position light lead
2. Wire harness
3. Main switch lead
4. Accessory light coupler
5. Joint coupler
6. Air temperature sensor lead
7. Front left turn signal/position light lead
8. Right handlebar switch lead
9. Main switch
10. Left handlebar switch lead
11. Air temperature sensor
A. Position the main switch coupler in the rear of the
headlight housing.
B. Fasten the wire harness at the white tape with the
holder.
C. Position the accessory light coupler and joint
coupler in front of the plate.
D. Fasten the main switch lead with the holder.
E. Fasten the front left turn signal/position light lead,
front right turn signal/position light lead, and joint
coupler lead with the holder.
F. Fit the right handlebar switch lead in between the
grommet and the main switch cover bracket,
making sure to push the lead all the way down.
G. Route the main switch lead under the headlight
bracket.
H. Pass the left and right handlebar switch leads
through the cutouts in the main switch cover.
I. Pass the left and right handlebar switch leads
between the cable guide and the upper bracket.
J. Fit the left handlebar switch lead in between the
grommet and the main switch cover bracket,
making sure to push the lead all the way down.
K. Fit the right handlebar switch lead in between the
main switch and the cable guide, making sure to
push the lead all the way in.
L. Route the right handlebar switch lead along the
grommet.
M. Pass the front left turn signal/position light lead
through the lead guide.
N. Route the main switch lead behind the plate.
O. Bend the projection on the lead guide to fasten the
front right turn signal/position light lead.
CABLE ROUTING (for XV19CS(C)/ XV19C(C))
2-70