Crankshaft; Removing The Connecting Rods; Checking The Crankshaft And Connecting Rods - Yamaha XV19SX(C) Service Manual

Table of Contents

Advertisement

EAS26010

REMOVING THE CONNECTING RODS

1. Remove:
• Connecting rod caps "1"
• Connecting rods
• Big end bearings
NOTE:
Identify the position of each big end bearing so
that it can be reinstalled in its original place.
EAS26090
CHECKING THE CRANKSHAFT AND
CONNECTING RODS
1. Measure:
• Crankshaft runout
Out of specification → Replace the crank-
shaft.
Runout limit C
0.040 mm (0.0016 in)
2. Check:
• Crankshaft journal surfaces
• Crankshaft pin surfaces
• Bearing surfaces
Scratches/wear → Replace the crankshaft.
• Generator shaft drive gear "1"
Damage/wear → Replace the crankshaft.
3. Measure:
• Crankshaft-pin-to-big-end-bearing clearance
Out of specification → Replace the big end
bearings.
Journal oil clearance (using plas-
tigauge®)
0.030–0.062 mm (0.0012–0.0024
in)
The following procedure applies to all of the
connecting rods.
ECA13930
CAUTION:
Do not interchange the big end bearings and
connecting rods. To obtain the correct
crankshaft-pin-to-big-end-bearing clear-
ance and prevent engine damage, the big
end bearings must be installed in their origi-
nal positions.
M
MMM
M MMM
M
M MMM
M
a. Clean the big end bearings, crankshaft pins,
and the inside of the connecting rod halves.
b. Install the big end upper bearing into the con-
necting rod and the big end lower bearing into
the connecting rod cap.
NOTE:
Align the projections "a" on the big end bearings
with the notches "b" in the connecting rod and
connecting rod cap.
c. Put a piece of Plastigauge® "1" on the crank-
shaft pin.
5-107

CRANKSHAFT

M MMM
M
M MMM
M
M MMM
M
MMM

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xv19cx(c)Xv19mx(c)Xv19ctsx(c)Xv19ctmx(c)Xv19csx(c)

Table of Contents