Installing The Swingarm - Yamaha XV19SX(C) Service Manual

REAR SHOCK ABSORBER ASSEMBLY AND SWINGARM
b
2
6. Tighten:
• Connecting-arm-to-relay-arm nut
Connecting-arm-to-relay-arm nut
59 Nm (5.9 m·kg, 43 ft·lb)
• Rear-shock-absorber-assembly-to-relay-arm
nut
Rear-shock-absorber-assembly-
to-relay-arm nut
40 Nm (4.0 m·kg, 29 ft·lb)
• Relay-arm-to-swingarm nut
Relay-arm-to-swingarm nut
59 Nm (5.9 m·kg, 43 ft·lb)
EAS28780

INSTALLING THE SWINGARM

1. Lubricate:
• Bearings
• Collars
• Oil seals
• Pivot shaft
Recommended lubricant
Lithium-soap-based grease
2. Install:
• Bearings "1"
(to swingarm)
Installed depth "a"
1.0 mm (0.04 in)
1
a
3. Install:
NOTE:
Temporarily tighten the pivot shaft nut.
4. Install:
NOTE:
When installing the connecting arm bolt, hold the
swingarm so that it does not drop down.
5. Tighten:
6. Adjust:
4-89
1 2
A
a
2. Swingarm
A. Left side
B. Right side
• Pivot shaft
• Washer
• Pivot shaft nut
• Connecting arm bolt (front side)
• Pivot shaft nut
• Engine mounting nut (rear lower side)
• Connecting arm nut (front side)
Pivot shaft nut
125 Nm (12.5 m·kg, 90 ft·lb)
Engine mounting nut (rear lower
side)
98 Nm (9.8 m·kg, 71 ft·lb)
Connecting arm nut (front side)
59 Nm (5.9 m·kg, 43 ft·lb)
• Drive belt slack
Refer to "ADJUSTING THE DRIVE BELT
SLACK" on page 3-26.
1
B
a