Table of Contents
Advertisement
WEEKLY
1. Flush tanks and solution lines with vinegar
solution (1 qt. Vinegar, 3 gals. Water).
2. Rinse with clean water.
3. Clean battery tops to prevent corrosion.
4. Check for loose or corroded battery cables.
MONTHLY
1. Lubricate axle and caster grease fittings with
water-resistant grease.
2. Lubricate all linkage pivot points with
silicone spray, then coat with a
water-resistant grease to maintain smooth
operation.
3. Check scrubber for water leaks and loose
nuts or bolts.
EVERY 250 HOURS
1. Check brush motor for carbon brush wear.
Replace when down to 3/8" or less.
Read carefully, any questions regarding the
CALL (800) 331-1423
The ProScrub is an innovative and unique machine. Since it was
first introduced it has undergone a process of continuous
improvement. This has been accomplished based on comments
and suggestions by customers and by the return of any defective
or failed parts. Examining causes of failures firsthand allows us
to solve current problems and avoid them in the future. While
this may at first seem to be an inconvenience, ultimately you
benefit from safer and more reliable products. Please give us the
opportunity to serve you better by following these RGA (Return
Goods Authorization) rules.
1. We maintain the serial number, date of shipment or sale, and
customer name on each piece of equipment sold. If you were
the purchaser, please reference that information on your
request for replacement or repair. If you purchased the equip-
ment through a dealer, please contact them.
2. Order the replacement part from your distributor or Aztec
Products, Inc. by calling 800.331.1423 between 8:30-5:00
Eastern Time. We will ship warranted parts at our expense.
PROTECT YOUR
WARRANTY!
care and safety of this unit, please
2. Check vacuum motor for carbon brush wear.
Replace when down to 3/8" or less.
BATTERY MAINTENANCE
Before any battery maintenance is done, make
sure batteries and charger are disconnected
and unplugged from wall outlet.
1. Keep battery tops and posts clean and dry.
To dissolve corrosion, mix a solution of
baking soda and water. Brush solution
carefully over battery tops and posts. Do
not allow solution to enter battery cells.
2. After drying tops and posts, use a wire
brush to clean terminal posts and cable
connections.
3. Thoroughly apply a coating of grease to
posts to help maintain a good connection
and prevent further corrosion.
4. Check for worn or loose cables and replace
if necessary.
3. When dealing with Aztec Products, Inc., ask for an RGA
number when you are ordering the replacement part.
Return the failed part to us within 30 days, freight prepaid,
exactly as it was at the time of failure. Our inspection and
evaluation will attempt to determine the probable cause of
failure.
4. If our inspection reveals that the failed part was defective, we
will credit your account for the entire amount of the part
including your cost of return freight.
5. We intend to be reasonable on any matter that is related to
our warranty service or other wear-related problems which
our customers feel need attention. Please help us to help
you. Before assuming that a part is defective, check the
repair manual to see if the problem might be something
that you or one of your employees might be capable of cor-
recting. If it is not, follow the above policy and depend on
us to respond quickly and responsibly.
ProScrub PG. 5
Advertisement
Table of Contents
