Yamaha HTR-6063 Owner's Manual page 19

Check that "SP IMP." is displayed on the front panel.
3
SP IMP. -8 MIN
4 Press STRAIGHT repeatedly to select a "6ΩMIN."
Switch this unit to the standby mode, and then
5
switch it on again.
The power turns on, when the settings you made has been
configured.
■
Connecting speakers
This type of jack can connect to the following speakers or
connection.
• Front L/R speakers
• Center speaker
• Surround L/R speakers
• Surround back L/R speakers
• Bi-amp connection (Front speaker L/R speakers)
3
F R
O N
T
2 2
1
4 4
Remove approximately 10 mm of insulation from the
1
ends of the speaker cables, and twist the bare wires
of the cables together firmly so that they will not
cause short circuits.
2 Loosen the speaker terminals.
Insert the bare wire of the speaker cable into the gap
3
on the side of the terminal.
4 Tighten the terminal.
CONNECTIONS
Connecting speakers
■
Connecting extra speakers
The EXTRA SP jacks can connect to the following speakers.
• Presence L/R speakers
• Zone2 speakers
Red: positive (+)
Black: negative (–)
E X
Z O
P R
Press down the tab and insert the bare end of the
1
speaker cable into the hole in the terminal.
Release the tab to secure the wire.
2
19
En