ABB Controlpanel Operating Instructions Manual page 85

ENG
3. Highlight the project in the project list and
press the "OK" button
4. The project is transferred from the
SD/MMC card into the room/control panel
and starts automatically.
5. The units exits the programming mode
automatically and the basic view is
displayed.
Programm- 1. Create the new project on a PC.
ing using
2. Connect the computer with the bus via an
the bus
RS 232 or a USB interface.
3: Press the "KNX Programming Mode" button
and enable it.
4. Start programming from the PC.
This process may take several hours.
44
KNX
KNX
Fig. 68
Fig. 69