Installing & Cleaning Foam Sleeve Filter; Troubleshooting - Vacmaster VBV809PF Operator's Manual

IMPORTANT!
Clean or change the cartridge filter regularly for best performance. ALWAYS USE
CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used with out the cartridge filter, the motor
will burn out and the warranty will be voided. Always keep spare filters on-hand.
NOTICE!
The filters included are made of high quality materials designed to stop small dust particles. The
cartridge filter should be used for dry pick-up only. A dry cartridge filter is necessary to pick up dust. If the
cartridge filter is wet, it will clog quickly and be very difficult to clean. Handle the filter carefully when removing
it for cleaning and replacing it. Check the filters for tears or small holes, a small hole can let dust pass through
and out of the cleaner. Do not use a filter with holes or tears, replace it immediately.
INSTALLING & CLEANING FOAM SLEEVE FILTER
INSTALLING & CLEANING FOAM SLEEVE FILTER
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Remove power head and place in upside down position. Follow instructions to remove
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole cage is covered.
(fig. 2 & 3)
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve filter. (fig. 4)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water. (fig. 5)
3. Allow filter to air dry before installing and using again.
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE TROUBLESHOOTING
Symptom
Vacuum will not operate
Dust comes from motor cover.
Reduced efficiency and
motor/speed vibration.

TROUBLESHOOTING

Possible Causes
1) No power supply.
2) Faulty power cord.
3) Container full.
cartridge filter
1) The
damaged.
1) There is a blockage in the nozzle,
hose, or the vacuum inlets. Or the
dust filter is blocked by fine dust.
Corrective Action
1) Check power supply – cord,
breakers, fuses.
2) Unplug and check the power
cord. If damaged, have it repaired
by a professional.
3) Empty container.
is missing or 1) Attach or replace the
filter
1) Check nozzle, hose and
container inlets for blockage. Take
off the filter and clean it. Or install
new filter.
11
cartridge filter.
cartridge
.