Mounting Bars - Rifton Z110 Product Manual

Mounting bars

To prevent falls or
WARNING
injuries, ensure that
the toilet is securely attached to the
fl oor and that the seat bolts are in good
condition before attaching the mounting
bar. Inspect the toilet stability and seat
bolts at regular intervals while the
mounting bar is in use.
There are two kinds of mounting bars, to fi t
either standard round, or elongated toilets
(see fi gure 11a).
The mounting bar attaches with the bolts
that hold the seat, and provides a fi rm
attachment point for the seat and back
units (see fi gure 11b).
To determine which type of mounting bar
you need, measure from the centerline
of the seat bolts to the front edge of the
porcelain bowl. Use a standard toilet
mounting bar if this is 17"(43 cm) or
less, otherwise use the elongated toilet
mounting bar.
Attachment of seat to
mounting bar
To prevent falls or
WARNING
injuries, ensure that
both hooks are fully engaged in the
sockets of the mounting bar before using
the HTS.
To attach the seat to the mounting bar,
move the backrest out of the way by tilting
or sliding it forward, then insert both
hooks on the seat into the sockets on the
mounting bar and lower the seat onto the
toilet bowl (see fi gure 11c).
Elongated
Standard
Figure 11a
Figure 11b
Hooks
Figure 11c
11