Ec Declaration Of Conformity - DeVilbiss JGA Series Operation Manual

E
E
Read and follow all instructions and Safety Precautions before using
The JGA Pressure Feed Spraygun Kit is approved to ATEX regulations 94/9/EC, protection level;
Important: These Sprayguns are suitable for use with most solvent based coating materials.
Nozzles and Needles are manufactured in Stainless Steel. These guns are not designed for use
with highly corrosive and/or abrasive materials and if used with such materials it must be
expected that the need for cleaning and/or replacement of parts will be increased. If there is any
doubt regarding the suitability of a specific material contact your local Distributor or ITW Finishing
direct.
Example:
Gun Number

EC Declaration of Conformity

We: ITW Finishing UK, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the
manufacturer of the Spraygun model JGA, declare, under our sole responsibility, that the
equipment to which this document relates is in conformity with the following standards or other
normative documents:
BS EN 292-1 PARTS 1 & 2: 1991, BS EN 1953: 1999; and thereby conform to the
protection requirements of Council Directive 98/37/EEC relating to Machinery Safety
Directive, and;
EN 13463-1:2001, council Directive 94/9/EC relating to Equipment and Protective
Systems intended for use in Potentially Explosive Atmospheres protection level II 2 G X.
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
© 2007 ITW Finishing Systems and Products
Operation Manual
JGA – Pressure Feed Spraygun
Important
this equipment
Description
II 2 G X Suitable for use in Zones 1, and 2
Model Part Number
JGA-558FWH-797
Fluid Tip Size
Aircap No
B. Holt, General Manager
30th June 2003
2