Toshiba e-studio 207l Troubleshooting Manual page 132

7 CHECKING THE EQUIPMENT STATUS WITH TopAccess
Error Code
File Sharing service is not available
2D68
NetWare service is not available
2D69
Failure to delete file
2DA6
Failure to acquire resource
2DA7
2DC0 Job canceled
Power failure occurred
2DC1
Store to USB
Wrong Job status
2E10, 2E12,
2E13
Not enough memory
2E11
Invalid parameter specified
2E14
Exceeding maximum file capacity
2E15
Failure to create directory
2E30
Failure to create file
2E31, 2E33
Failure to delete file
2E32
130 Error Codes
Problem Description Corrective Action
Ask your administrator whether the SMB
protocol is enabled.
Ask your administrator whether the NetWare
protocol is enabled.
Delete the files in the shared folder with
Explorer, turn the power OFF and then back
ON, and reattempt the problem job. If the
error still persists, contact your service
representative.
Turn the power OFF and then back ON. Try
the problem job again. If the error still
persists, contact your service representative.
The job was canceled.
Make sure that the power cable is
connected properly and is inserted securely.
Resend the job.
Turn the power OFF and then back ON. Try
the problem job again. If the error still
persists, contact your service representative.
Wait for a while and try again. If the error still
persists, turn the power OFF and then back
ON, and make another effort.
If you are using a template, create it again. If
the error still persists, turn the power OFF
and then back ON, and then try again.
Divide the file into several files, or reattempt
in a single-page format.
Make sure that the access privilege to the
storage directory is writable and also that the
disk in the directory has enough space, and
then try again. If more than one job is
performed simultaneously, the error may
occur because the disk temporarily runs out
of space. In this case, wait for a while and try
again. If the error still persists, turn the
power OFF and then back ON, and make
another effort.
Make sure that the access privilege to the
storage directory is writable and also that the
disk in the directory has enough space, and
then try again. If more than one job is
performed simultaneously, the error may
occur because the disk temporarily runs out
of space. In this case, wait for a while and try
again. If the error still persists, turn the
power OFF and then back ON, and make
another effort.
Turn the power OFF and then back ON. Try
the problem job again. If the error still
persists, contact your service representative.