Installation - Kyocera IB 21 User Manual

Installation

The duplexer fits onto the bottom of the printer or of the optional paper feeder (if
the optional paper feeder is installed together with the duplexer).
CAUTION
Before installing (or removing) the duplexer, be sure to turn
off the printer's power.
Figure 2 on page iv shows allowable printer configurations including the duplexer.
Depending on other optional units installed together with the duplexer, different
paper path adaptors are required. Note that any configuration containing the
duplexer also requires the optional paper handler/stacker. For details on how to
install the optional paper handler, see the instructions provided with the optional
paper handler/stacker.
Installing the duplexer with no other option units
If the duplexer is the only option unit you will be using with the printer, it mounts
directly underneath the printer as shown in Figure 2(a). The printer sits directly on
top of the duplexer.
1. Install the optional PA-20 paper path adaptor on the duplexer as shown
in Figure 3.
Pull the duplexer drawer slightly open.
Align the tabs with the slots.
After fitting the tabs to the slots, slide the paper path adaptor to the
left to lock.
Close the duplexer drawer.
2.
Next, align the positioning pins on top of the duplexer and the lock pin
on the paper path adaptor with the holes in the base of the printer, then
slowly and carefully lower the printer onto the duplexer. Hold the printer
level while lowering it onto the duplexer, and make sure that the
connector on the duplexer fits squarely into the corresponding connector
in the base of the printer. (Fig. 4)
3.
Install the optional paper handler/stacker. For details, see the instructions
provided with the paper handler/stacker.
6