Kyocera IB 21 User Manual page 22

Installing the duplexer together with other option units
The duplexer mounts underneath the paper feeder as shown in Figure 2(b). In this
configuration, the printer sits on top of the paper feeder.
1.
If you will be using the duplexer together with a paper feeder, you must
install the PA-1 paper path adaptor on the rear of duplexer. Install the
PA-1 as shown in Figure 5.
Align the tabs with the slots.
After fitting the tabs to the slots, slide the paper path adaptor in the
direction indicated by the arrow to lock it. See Figure 6 for how to
remove the PA-20.
2.
Next, install the paper feeder on top of the duplexer as shown in Figure
7. Align the positioning pins on top of the duplexer and the lock pin on
the paper path adaptor with the holes in the base of paper feeder, then
carefully lower the paper feeder onto the duplexer. Hold the paper feeder
level while lowering it onto the duplexer, and make sure that the
connector on the duplexer fits squarely into the corresponding connector
in the base of the paper feeder.
Note
You can stack two paper feeders on top of one another. For
details, see the paper feeder instruction manual.
3.
Install the optional PA-20 paper path adaptor on the paper feeder as
shown in Figure 3.
Align the tabs with the slots.
After fitting the tabs to the slots, slide the paper path adaptor to the
left to lock.
4. Lower the printer onto the paper feeder. Observe the same precautions as
when lowering the paper feeder onto the duplexer. (Fig.4)
5.
Install the optional paper handler/stacker. For details, see the instructions
provided with the paper handler/stacker.
7