Interface
Network Interface Parameters
This printer supports TCP/IP , NetWare and EtherTalk protocols. In
addition, you can install the option network interface card in the option
interface slot.
Using the operator panel, you can:
•
Activate or deactivate TCP/IP , NetWare, and EtherTalk
•
Activate or deactivate DHCP
•
Enter IP address, subnet mask address, and default gateway address
To confirm or change network card parameters, proceed as follows:
1
Press the MENU key.
2
Press the
or
the interface names shown below appears, indicating the current
interface.
Parallel (default)
USB
Network
Serial (when a serial interface board kit is installed)
Option (when a network interface card is installed)
3
Press the ENTER key. A blinking question mark (?) appears.
Interface
? Parallel
If the option network interface card is installed in the printer,
Option will be displayed. The setting procedure is basically the
same even in this case.
4
Press the
or
Interface
? Network
5
Press the ENTER key again.
key repeatedly until Interface > appears. One of
key repeatedly until Network appears.
1-78