Faqs - Bauhn ASB-811 Instruction Manual

FAQs

Problem
No picture.
Screen shows
"No signal".
No sound from the
speaker.
Only sound, no
image on
the screen.
Remote control
does not work.
The image stops
suddenly or is
pixelated.
16
Potential cause
The power is not connected. Connect the power.
The power is not switched
on.
The TV is set to the wrong
input.
The output resolution is too
high for the TV.
Incorrect or no connection
with AV cable.
The antenna cable is not
connected.
Incorrect setting.
Incorrect or no connection
with audio cable.
The sound is muted.
Incorrect sound track.
Incorrect or no connection
with AV cable.
The program is a radio
program.
The batteries are exhausted. Insert new batteries.
The remote control unit is
not pointed correctly at the
front panel or is too far from
it.
The signal is too weak.
Solution
Switch on the power.
Select the correct input
source on the TV.
Press the GREEN
button to try another
resolution.
Connect the video cable
correctly.
Plug in the antenna
cable.
Set up the correct
parameters.
Make sure the audio
cable is connected
correctly.
Switch on the correct
volume control.
Try another sound track.
Connect the video cable
correctly.
Press the [TV/RADIO]
key to shift into TV
mode.
Adjust the way of
holding the remote
control unit and get
nearer to the front
panel.
Try adjusting the aerial,
(or consult an antenna
specialist).
After Sales Support
Telephone:
1300 886 649
Email: info@tempoaustralia.com.au