Faqs - Bauhn AS-PVR1000R Instruction Manual

FAQs

If you experience problems with this HDD PVR or its installation, in the first instance
please read carefully the relevant sections of this instruction manual. If none of the
solutions help you solve your problem, contact the after sales support line.
Problem
The display on the
front panel is not lit.
No signal found.
No picture or sound.
Mosaic blocks in
picture or picture
freezes.
Scrambled channel
message.
Locked out of the
channel.
No response to the
remote control.
After moving the
receiver to another
room, the HDD PVR
cannot receive the
digital signal.
The picture and
sound freezes when
in time-shift mode.
30
Possible cause
Cord is unplugged.
Main fuse is blown.
Aerial is disconnected.
Aerial is damaged/misaligned. Check the aerial.
The channel is not
broadcasting now.
Aerial may not be suitable.
Channel is scrambled.
Parental control enabled.
Receiver is not plugged in.
Remote control is not aimed
correctly.
Front panel is obstructed.
Remote control batteries are
inserted incorrectly.
Batteries are exhausted.
The aerial feed may now be
reduced due to signal path.
This may happen if you are
recording two different
channels, due to the storage
device speed.
Solution
Check the mains lead.
Check the fuse.
Check the aerial lead.
Select another channel.
Check the aerial.
Select an alternative
channel.
Enter your password.
Plug in and turn on the
receiver.
Aim the remote control at
the front panel.
Remove obstructions.
Make sure the batteries
are inserted correctly.
Replace the remote
control batteries.
Try a direct feed from the
antenna.
Only enable time-shift
mode when recording
one channel.
After Sales Support
Telephone:
1300 886 649
Email: info@tempoaustralia.com.au