Kyocera FS FS-1020D Operation Manual page 29

Printed Results
Faint or blurred printing
Grey background.
Dirt on the top edge or back of the paper
Table 3-2 (Continued)
Corrective Action
Check the EcoPrint setting.
When this setting is On, switch it to Off on the KM-NET
for Clients. (See the
Guide.)
Confirm the (toner) indicator.
If the (toner) indicator flashes, install a new toner
kit. (See Chapter 2)
Clean the charger wire.
Open the printer's top and front covers. Remove the
process unit from the printer and slide the charger knob
back and forth to clean the charger wire.
(See Chapter 2)
Try setting the thin paper mode.
Set the paper type to Thin in the KM-NET for Clients
KM-NET for Clients Operation
utility. (See the
Guide.)
If the toner is not being fixed well to the paper,
adjust the corresponding custom paper type
setting.
When selecting the settings for the custom paper type
under the Custom Paper Type Settings, be sure to select
Normal 3 as the corresponding weight in the KM-NET for
Clients. (See the KM-NET for Clients Operation
Guide.)
Check the operator panel.
When the (toner) indicator flashes, install a new
Chapter
toner kit. (See
Check the process unit.
Open the printer's top and front covers, then check that
the process unit is properly installed.
Check the transfer roller.
Open the printer's top and front covers. Remove the
process unit from the printer and check whether the
transfer roller is dirty. If so, print several pages to
eliminate the dirt.
Check the registration roller.
Open the printer's top and front covers. Remove the
process unit from the printer and check whether the
registration roller is soiled with toner. If so, wipe it clean
using the supplied wiper cloth.
3-4
Print Quality Problems
KM-NET for Clients Operation
2)