Print Quality Problems - Kyocera FS FS-1020D Operation Manual

3.2

Print Quality Problems

Printed Results
All-black printout
Dropouts, horizontal streaks, stray dots
Black or white vertical streaks
Table 3-2
As the following table shows, there are many possible causes of print
quality problems, such as blank output as. The troubleshooting procedure
for each type of problem is explained below. If you still can not solve the
problem, contact your Kyocera Mita dealer.
Corrective Action
Contact your Kyocera Mita dealer.
Clean the charger wire.
Open the printer's top and front covers. Remove the
process unit from the printer and slide the charger knob
back and forth to clean the charger wire.
(See Chapter 2)
Check the operator panel.
When the (toner) indicator flashes, install a new
toner kit. Clean the printer after replacement.
(See Chapter 2)
Clean the charger wire.
Open the printer's top and front covers. Remove the
process unit from the printer and slide the charger knob
back and forth to clean the charger wire.
(See Chapter 2)
Check the position of the charger cleaner knob.
Open the printer's top and front covers. Remove the
process unit from the printer. Make sure the charger
cleaner knob is restored to its home position.
Chapter 2)
(See
Change the corresponding custom paper type
setting.
When selecting the settings for the custom paper type
under the Custom Paper Type Settings, be sure to select
Normal 1 as the corresponding weight in the KM-NET for
KM-NET for Clients Operation
Clients. (See the
Guide.)
3-3
Print Quality Problems