Page 1
Lulworth ELECTRIC F F IRE INSTALLATION A A ND U U SER INSTRUCTIONS All i i nstructions m m ust b b e h h anded t t o u u ser f f or s s afekeeping Revision A - 05/04...
Sec c tion Contents Page N N o. Sec c tion Contents P age N N o. Fitting the decorative frame & front Important Notes Assembling the fuel bed Installation Requirements Operating the Appliance Appliance Data Safety Cutout System Unpacking the Appliance Maintenance Component Checklist Cleaning...
. Lulworth Models: The pebbles should not be placed over the shelves ‘holes’, which are below the curved panel. These should be left, at least particially un-obscured, so that the effect can be seen on the rear panel.
Page 4
To operate the fire, the left switch must be turned on first, followed by the second switch to start the blower, if required. To obtain heat from the appliance, the I switch must then be operated for LOW (1kW) of heat, followed by the II switch for the HIGH setting. It is not possible to obtain heat from the appliance without first switching on the main power switch (OI) and the fan blower switch (*) in con- junction with either the LOW (I) or both the LOW and HIGH (II) switches.