Jungheinrich EZS 350 Operating Instructions Manual page 66

No. Function
003 Delete code
004 Delete code log (deletes
all codes)
010 Automatic timeout
LEDs 60-62 are located in keypads 1-3.
Assigning the starting travel program (depending on the truck)
The travel programs are connected to the code. The travel programs can be
individually released or blocked for each code. A starting travel program can be
assigned to each code.
Once a user code has been set up, all travel programs are globally released, the valid
start travel program is travel program 2.
The code configuration can then be changed with program number 024.
No. Function
024 Code configuration
1. digit: travel program 1 release (0 = blocked or 1 = released)
2nd digit: travel program 2 release (0 = blocked or 1 = released)
3rd digit: travel program 3 release (0 = blocked or 1 = released)
4th digit: start travel program (0, 1, 2 or 3)
Setting range
0000 - 9999
or
00000 - 99999
or
000000 - 999999
3265
00-31
Setting range
Standard Procedure
setting
– (LED 61 flashes)
Confirm new code
entry
–
(Set 64)
– (LED 62 flashes)
repeat code entry
–
(Set 64)
– 3265 = delete
– other inputs = do
not delete
00 – 00 = No timeout
– 01 - 30 = Timeout
in minutes
– 31 = Timeout after
10 seconds
Standard Procedure
setting
1112
65