Jungheinrich EZS 350 Operating Instructions Manual page 64

Parameter Groups
The parameter number is composed of three digits. The first digit refers to the
parameter group as shown in Table 1. The second and third digits are numbered in
sequence from 00 to 99.
No. Parameter Groups
0XX Code lock settings (codes, travel program release, automatic cutout, etc.)
7.2.3 Parameter Settings
To change the truck settings you must enter the master code.
Z
The master code factory setting is 7-2-9-5. Change the master code the first time
you use the truck.
Z
Set different codes for rider and pedestrian trucks.
Changing the truck settings
Procedure
• Press the O key (63).
• Enter the master code.
• Enter the three-digit parameter number.
• Confirm with the SET key (64).
• Enter the setting as per parameter list.
Z
If the entry is incorrect, the LED (65) of the O key (63) turns red.
• Enter the parameter number again.
• Enter the setting again or change it.
• Confirm with the SET key (64).
• Repeat the procedure for other parameters.
• Then press the O key (63).
The settings are now saved.
63