Icom IC-M323 Instruction Manual page 35

After transmitting the call, the transceiver waits for an ac-
t
knowledgment call.
• The Distress call is automatically transmitted every 3.5 to 4.5
minutes, until an acknowledgement is received ('Call repeat'
mode), or DSC cancel call is made (p. 26).
• Push [RESEND] to manually transmit the Distress repeat call.
• Push [Ω]/[≈] then push [INFO] to display the transmitted Dis-
tress call information.
• Push [Ω]/[≈] then push [PAUSE] to pause the 'Call repeat' mode,
push [RESUME] to resume it.
After receiving an acknowledgment call, push [ALARM
y
OFF] then reply using the microphone.
A distress alert contains:
➥
• Nature of distress: Selected in step w.
• Position information: The latest GPS or manually entered
position is held for 23.5 hours, or until
the power is turned OFF.
When no GPS receiver is connected and built-in GPS re-
ceiver* is not receiving valid position data, and both posi-
tion and time have been manually entered, the screen as
shown below is displayed. Edit your latitude and longitude
position and UTC time as follows:
*For only IC-M323G and IC-M324G.
Push [CHG], then edit your latitude and longitude posi-
➥
tion and UTC time.
• Select a desired number using Dial, or [Y]/[Z]/[Ω]/[≈].
• Push [ENT] or Dial to set it.
• To move the cursor, select either arrow, "←" or "→," then push
[ENT] or Dial.
• Select N (North latitude) or S (South latitude) when the cursor
is on the 'N' or 'S' position.
• Select W (West longitude) or E (East longitude) when the cur-
sor is on the 'W' or 'E' position.
7
DSC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
25