Operation
6.2 Filling regeneration salt
Possible risk of damage to the water softener
Chemicals such as detergent and rinse aid inevitably lead to damage to the water softener.
Fill only with regeneration salt or pure evaporated salt.
Caution
Possible malfunction of the water softener
Do not fill with other salts (e.g table salt cleaning or de-icing salt). These can contain water-
insoluble components. Fill only with fine-grained salt (max. 0.4 - 7 mm grain size).
Salt tablets are not suitable.
INFO
Proceed in accordance with Figures B1 to B5.
Figure B2 is only relevant for the first filling.
IMPORTANT
Risk of rust formation in the filling area
Immediately after filling, start a wash cycle to rinse off any salt residue.
Caution
7
Operation
7.1 Before switching on the machine
Possible risk of damage due to suction of items from within the machine e.g. pieces of
cutlery
The pump inlet filter protects the circulating pump and the drain pump. Operate the machine
Caution
only with the pump inlet filter fitted.
7.2 Switching on the machine and preparing it for operation
Press the On/Off button.
The display is lit in red.
As soon as the machine is ready for operation, the display is lit in green.
8
Open the water shut-off valve.
Switch on the local mains disconnector.
For your own safety, test the on-site residual-current circuit
breaker (F1).
Open the hood.
Remove the filter cylinder (1).
Check whether the pump inlet filter (2) is fitted.
Replace the filter cylinder (1).
Check whether the rotary wash arms (top and bottom) are
fitted and properly engaged.
Close the hood.
Check whether sufficient detergent and rinse aid are pre-
sent in the storage containers. Replace the storage con-
tainers in time so that the wash results are not affected.