Priming The Dosing Devices; Integral Water Softener (Optional); Lack Of Salt Display; Refilling Salt - Winterhalter P50 Operating Instructions Manual

Procedure:
 Observe the safety precautions when handling chemicals and the dosage recommendations
on the packaging.
 Wear protective clothing, protective gloves and protective goggles when handling chemicals.
Danger
 Do not mix different detergents.
 Remove the suction stick from the container and place it in a water-filled container.
 Rinse the dosing hose and the detergent dosing device with water. To do this, use the "priming the dos-
ing device" function several times ( 13). The frequency depends on the length of the hose.
 Place the suction stick in the new detergent container.
 Use the "priming the dosing device" function several times ( 13), to replace the water in the dosing hose
with detergent.

6.4 Priming the dosing devices

Dosing devices must be primed when air is reached in the dosing hoses because the containers were not
exchanged in time ( 13).
7

Integral water softener (optional)

By softening the inlet water, limescale build-up in the machine and on the dishes is avoided. For the integral
water softener to work correctly, the salt container must be filled with regeneration salt.
When commissioning the machine, the authorised service technician measures the water hardness and en-
ters the respective value.

7.1 Lack of salt display

On the display, a pictogram is shown when the salt container is empty and needs to be
refilled. The pictogram disappears when the salt container has been refilled, as soon as
approx. 3 wash cycles have been completed and part of the salt has been dissolved.

7.2 Refilling salt

Possible risk of damage to the water softener
Chemicals such as detergent and rinse aid inevitably lead to damage to the water softener. Fill
only with regeneration salt or pure evaporated salt.
Caution
Possible malfunction of the water softener
Do not fill with any other types of salt (e.g. table salt or de-icing salt). These may contain water-
insoluble components. Only fill with fine-grained salt (max. 0.4-7 mm grain size).
INFO Due to their size, salt tablets are not suitable.
 Proceed in accordance with the following figures:
Danger of rust formation in the filling area
After filling the regeneration salt, start a wash cycle in order to wash away any salt residues that
may be present.
Caution
Integral water softener (optional)
7