Scanning Sequence Examples; Errors While Scanning; User Preferences/Miscellaneous Options Parameter Defaults - Motorola Symbol DS6708 Product Reference Manual

4 - 2 Symbol DS6708 Digital Scanner Product Reference Guide

Scanning Sequence Examples

In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high, scan
the High Frequency (beeper tone) bar code listed under
fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Time-Out or Data Transmission Formats, require scanning several
bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

User Preferences/Miscellaneous Options Parameter Defaults

Table 4-1 lists defaults for user preferences parameters. There are two ways to change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Configure the digital scanner using the 123Scan configuration program (see
NOTE See
miscellaneous default parameters.
User Preferences Parameter Defaults
Table 4-1
Parameter
User Preferences
Set Default Parameter
Parameter Scanning
Beeper Tone
Beeper Volume
Power Mode
Time Delay to Low Power Mode
Trigger Mode
Picklist Mode
Decode Session Timeout
Timeout Between Decodes, Same Symbol
Beep After Good Decode
Appendix A, Standard Default Parameters
Beeper Tone on page
Set Default Parameter on page
for all user preferences, hosts, symbologies, and
Parameter
Default
Number
All Defaults
ECh Enable
91h Medium
8Ch High
80h Continuous On
92h 1 Minute
8Ah Auto Aim
F0h 92h Disabled Always
88h 9.9 Sec
89h 0.6 Sec
38h Enable
4-5. The digital scanner issues a
4-4.
Chapter 12, 123Scan).
Page
Number
4-4
4-4
4-5
4-6
4-6
4-7
4-8
4-9
4-10
4-10
4-11