5 - 2
Symbol DS6708 Digital Scanner Product Reference Guide
Scanning Sequence Examples
In most cases scanning one bar code sets the parameter value. For example, to disable the decode aiming pattern,
scan the Disable Decode Aiming Pattern bar code listed under
scanner issues a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters require scanning several bar codes. See these parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
Decoding Preferences Parameter Defaults
Table 5-1
lists the defaults for decoding preferences parameters. There are two ways to change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Configure the digital scanner using the 123Scan configuration program (see
NOTE See
miscellaneous default parameters.
Decoding Preferences Parameter Defaults
Table 5-1
Decoding Options
Decoding Illumination
Illumination Bank Control
Decode Aiming Pattern
Appendix A, Standard Default Parameters
Parameter
Decode Aiming Pattern on page
Set Default Parameter on page
for all user preferences, hosts, symbologies, and
Parameter
Number
F0h 2Ah
Enable
F1h 3Bh
Full Illumination
F0h 32h
Enable
5-5. The digital
4-4.
Chapter 12,
123Scan).
Page
Default
Number
5-3
5-4
5-5