Toshiba e-Studio RD30 User Manual page 34

Supplemental Information when Using the Product
• This equipment supports the following paper.
A/B format: A4, A5, B5 (64 - 80 g/m
LT format: LT, ST (17 - 20 lb. Bond)
• The following 3 public templates are registered as the default.
- Erasure and sorting
- Scan and save in USB media
- Erasure only
• Pressing [START/WAKEUP] on the Status Display screen after loading the
paper runs the top template.
• This equipment only supports USB media that meets the following
conditions:
- FAT32 format
- Single-partition
• When executing "Scan_USB", connect one USB media to the left or right
side of this device.
• When the ink cartridge is installed and the reuse counter function
enabled, reuse counter marks are printed on the upper left corner and
lower right corner of the paper.
function in TopAccess.
TopAccess Guide : "Chapter 7: [Administration] Tab Page" -
"[Setup] Item List"
• It takes approximately 50 seconds before erasing is started in an
environment where the temperature is 15˚C (59˚F) or less.
34
2
)
You can configure the reuse counter
Refer to the TopAccess Guide for details.
Supplemental information
on paper
Supplemental information
on control panel
Supplemental
information on
this equipment