Table of Contents Getting Started _________________________________________________ 1-1 PACKAGE CONTENTS _________________________________________ 1-1 PHYSICAL DESCRIPTION ______________________________________ 1-2 CONNECT NECESSARY CABLES _______________________________ 1-6 Quick Tour ____________________________________________________ 2-1 Configure the IP Camera _______________________________________ 2-1 2.1.1 Make sure network environment _________________________________________ 2-1 2.1.2 Open Internet Explorer with IP address____________________________________ 2-2 2.1.3 Login with default administrator’s account &...
1.2 PHYSICAL DESCRIPTION Microphone Input Sensitivity: -44dB(0dB=1Vpp at 1KHz) S/N Ratio: More than 58dB Directivity: Omni directional Auto Iris Video / DC (switchable) Video DC Level Adjustment CCD Functions Auto Electronic Shutter Speed Mode AES On: 1/50 (60) sec. ~ 1/100,000 sec; AES Off: 1/50 (60) sec.
Page 5
AWB / Push Lock WB Mode WAN port The IP Camera connects to the WAN (wide area network) via a standard RJ45 connector. Supporting NWAY, this IP camera can auto detect the speed of local network segment (10Base-T/100Base-TX Ethernet). The WAN port is for FTTH and can connect to a xDSL or cable modem.
Page 6
camera will gets the power from the first power input plugged into NOTE: You may find a support package for help you getting familiar with PoE. Please visit our web site, and get the support document TS-00040. Analog Video Output The IP camera supports one channel analog video output.
Page 7
NAME DESCRIPTION Ground Pin Digital Input Ground Pin Digital Output...
1.3 CONNECT NECESSARY CABLES The Ethernet cable and power cable are necessary for previewing function. Make sure all cables are correctly and firmly connected. 1. Connect an analog monitor to IP Camera video out (BNC connector). 2. Connect the power adaptor to IP Camera 3.
Quick Tour This section guides you with a quick tour on IP camera. 2.1 Configure the IP Camera 2.1.1 Make sure network environment Default IP of IP camera is 192.168.0.100. Please make sure IP camera and your PC are on the same network segment before running the installation. Please set the settings as below.
2.1.2 Open Internet Explorer with IP address NOTE: If your web browser is earlier than IE6, then download IE6 is recommended. NOTE: The IP camera default IP address is set to 192.168.0.100 2.1.3 Login with default administrator’s account & password NOTE: Default administrator account is set to Admin, password is set to 123456, and click...
2.1.4 Preview the video NOTE: In your Client PC, please make sure the setting of Network Connections Type is set to Auto Negotation, since IP camera follows MII standard. Otherwise, you might not see the live image.
2.1.5 Set the new IP address Host Name : Enter in the domain name, Default Host Name is ACTi. Language : Language setting for Web Configurator after Save Reboot. Default setting is English. IP Address : The IP address of the LAN interface. The default IP address is 192.168.0.100.
2.1.6 Check Default Video Setting NOTE: Please make sure the TV Input (NTSC / PAL) is meet your requirement, and click button. 2.1.7 Click Save Reboot to restore all settings and please wait about 30 seconds for system reboot.