Fog Lamps; Rear Tail, Stop, Turn Signal, Side Marker And Backup Lamps - RAM 2013 Cargo Van Owner's Manual

Hide thumbs Also See for 2013 Cargo Van:

Table of Contents

2. Twist the turn signal socket and remove from the

headlamp housing, then pull the bulb out.

3. Push the new bulb into the socket and reinstall the

socket by twisting until locked into the headlamp

Fog Lamps

NOTE: Access to the fog lamp bulb is from the rear of

the fascia. On the left rear side of the fascia, remove the

push pin and lower the hinged access door on the air

1. From behind the bumper fascia, or the access panel on

the air dam, squeeze the two tabs on the side of the

bulb socket and pull straight out from the fog lamp.

Do not touch the new bulb with your fingers. Oil

contamination will severely shorten bulb life. If the

bulb comes in contact with an oily surface, clean the

bulb with rubbing alcohol.

2. Disconnect the wire harness from the bulb.

3. Reconnect the wiring harness to the new bulb and

reinstall by inserting the new bulb straight into the fog

lamp until it locks into place.

Rear Tail, Stop, Turn Signal, Side Marker And

Backup Lamps

1. Raise the liftgate.

I n f o r m a t i o n P r o v i d e d b y :

MAINTAINING YOUR VEHICLE 625

Table of Contents