RAM 2013 Cargo Van Owner's Manual page 426

424 UNDERSTANDING YOUR INSTRUMENT PANEL
CAUTION!
Failure to follow these cautions can cause damage to
the heating elements:
• Use care when washing the inside of the rear
window. Do not use abrasive window cleaners on
the interior surface of the window. Use a soft cloth
and a mild washing solution, wiping parallel to the
heating elements. Labels can be peeled off after
soaking with warm water.
• Do not use scrapers, sharp instruments, or abrasive
window cleaners on the interior surface of the
window.
• Keep all objects a safe distance from the window.
9. Recirculation Control Button
Press this button to choose between outside air
intake or recirculation of the air inside the
vehicle. A lamp will illuminate when you are in
Recirculation mode. Only use the Recirculation
mode to temporarily block out any outside odors, smoke,
or dust, and to cool the interior rapidly upon initial
start-up in very hot or humid weather.
NOTE:
• If the Recirculation button is pressed when the system is
in Defrost mode the Recirculation LED indicator will flash
3 times to indicate Recirculation mode is not allowed.
• In Floor and Mix mode the system will turn off Recir-
culation mode after five minutes of operation. You can
select Recirculation mode again if desired.
• Continuous use of the Recirculation mode may make
the inside air stuffy and window fogging may occur.
Extended use of this mode is not recommended.
I n f o r m a t i o n P r o v i d e d b y :