Fog Lamps - If Equipped; Rear Tail/Stop, Turn Signal And Backup Lamps - RAM 2015 1500 Operating Information Manual

NOTE:
There are access covers over both head-
lamp bulb access holes in the quad front
lamp unit housing (if equipped). These cov-
ers MUST be reinstalled after the bulb has
been replaced.
Fog Lamps — If Equipped
1. Reach under and behind the front bumper to
access the back of the front fog lamp housing.
2. Disconnect the fog lamp wiring harness con-
nector from the fog lamp bulb.
3. Rotate the bulb counterclockwise ¼ turn to
unlock the bulb from the housing.
4. Pull the bulb straight out from the housing.
CAUTION!
Do not contaminate the bulb glass by touch-
ing it with your fingers or by allowing it to
contact other oily surfaces. Shortened bulb
life will result.
456
Rear Tail/Stop, Turn Signal And
Backup Lamps
1. Remove the two screws that pass through
the bed sheetmetal.
Tail Lamp Screw Locations
2. Pull the outboard side of the lamp rearward
far enough to unsnap the two receptacles on
the outboard side of the lamp housing from
the two plastic snap post retainers in the
outer box side panel.
Pulling Out The Tail Lamp
3. Disconnect the wiring harness connectors
from the bulb socket.
4. Rotate the bulb socket counterclockwise 1/4
turn to unlock it from the housing.
5. Pull the bulb straight out of the socket.
CAUTION!
Do not contaminate the bulb glass by touch-
ing it with your fingers or by allowing it to
contact other oily surfaces. Shortened bulb
life will result.