Table of Contents
Advertisement
09. Product functions /Pin arrangement info.
Functions
Operation
Supplying power
Updating
A 20-second long video, taken five seconds
before an accident to 15 seconds after it, will
Monitoring while parked
detected by the front or (and) rear camera(s)
Removing the power cable port
/ Turning off the power switch
Port pin arrangement
Ports
Power port
(DC socket)
GPS port
(2.5 pie)
Front camera connection port
(Micro USB 5P)
Rear camera connection port
(Micro USB 5P)
State
After booting is completed
Updating through the micro SD card
be recorded when a motion or a shock is
The last video will be recorded using the
backup battery before the power is turned
off.
Images
3
4
3
Voice notification
"Recording is now in progress"
-
When entering - "Recording is now
in progress"
-
2
1
① GND ② ACC ③ BAT (B+)
2
1
① VCC(3.6–6V DC) ② Rx
③ GND ④ Tx(GPS Signal Output)
1
① VCC(5.0V DC) ② Video signal –
. .
③ Video Signal + ④ No use
.
⑤ GND
5
1
① VCC(5.0V DC) ② Video signal –
. .
③ Video Signal + ④ No use
.
⑤ GND
5
LED indication
The
blue
LED will turn on during boot-up, and will blink
when booting is completed. The
green
side of the LCD screen will turn on. The
LED light for the rear side will blink.
The
blue
LED will blink while updating is progressing and
the
blue
LED will be turned off when the process is
completed. The LED will turn on again when the system
starts again.
- Monitoring activated: The
blue
LED will blink every
second
- Motion detection and recording: Blinking four times
every second
- Shock recording: Blinking six times every 1 second
-
Pin arrangement
LED at the right
blue
security
14
Advertisement
Table of Contents
