Table of Contents
Advertisement
Configuring the Printer
Parameter
CR+LF
LEFT MARG. (1/60")
TOP MARG. (1/6")
TOP MARG. (1/60")
ZERO SLASH
LINE LENGTH
RESET WHEN EJECT
PNS SELECTION
PNS #2100K
PNS #2101K
PNS #2102K
3-22
LQ CONFIGURE
Option
Explanation
NO
YES: CR = LF + CR
YES
NO: CR = CR
0
To adjust the left margin
-6 up to +6
more to left or right in units
of 1/60" inch (about 4 mm).
0
Adjust the top margin in
-1 up to +6
units of 1/6 inch.
0
Adjust the top margin in
-5 up to +5
units of 1/60 inch (about
4 mm).
NO
Select the printout of 0
YES
(0x30 = zero)
YES = the 0 will be printed
with a slash on it (e.g. 0 / ).
80
Setting the line length in
90
unit of character of 10 CPI.
94
NO
NO = no reset
YES
YES = the printer will be
reset when eject a form.
NO
Whether the following PNS
YES
item is valid or not.
NO
YES = Reset automatically
YES
line condensation when
Form Feed command
executed.
NO = no reset
NO
NO = ignore 0x20 at the
YES
end of a line.
YES = don t ignores 0x20
at the end of a line.
NO
YES = Process of the
YES
horizontal and vertical
movement command:
ESC $; ESC \; ESC (v)
NO = ignore the command
Note
TOF = Top Of Form
TOF = Top Of Form
Only displayed if PNS
SELECTION is set to
YES.
Only displayed if PNS
SELECTION is set to
YES.
Only displayed if PNS
SELECTION is set to
YES.
This PNS is only active
on ver. 1.08 or higher.
Advertisement
Table of Contents
