Table of Contents
Advertisement
3.7.6 MAGNETIC TEST
The Magnetic Test is for the optional Magnetic Stripe Reader / Writer. It works only for the
PR 9/K with the firmware version 1.07 or higher.
Note:
The optional Magnetic Stripe Reader / Writer in a special version and not used in
Europe.
3.8
INFO INQUIRING
You get information of the current setting parameters of software or hardware. This
information is important for the system engineer and service staff.
You can select the following parameter:
S FW VERSION
S HW CONFIGURATION
S PRINTER ID
3.8.1 FW Version
The parameter firmware version shows:
S version number
S special version tag
Note:
In this sample indicates VER2.09 the version number (firmware release), and T7 the
special version tag.
3.8.2 HW Configuration
The parameter hardware configuration gives information over:
S characters generators
S optional interface
S scanner (only with Magnetic Test)
3.8.3 Printer ID
The display shows the identification of the printer:
e.g.:
FW VERSION
VER2.09 T7FPGA:2.4
e.g.:
HW CONFIGURATION
GB18030 CX
e.g.:
PRINTER ID
00000AECE8AD01
Configuring the Printer
3-37
Advertisement
Table of Contents
