Completing The Installation - Quantum LTO-3 Quick Start Manual

LTO-3 (Model B), LTO-4 (Model B), LTO-5, and LTO-6
Completing the
Installation
Figure 27 Sliding the 1U Rack
Enclosure into the Rack
22
To complete the rackmount enclosure installation:
1 Extend the stabilizing feet if provided on your rack.
2 Extend the left and right rack rails from the front of the rack.
3 Align the rear of the component rails on the tape enclosure with the front ends of
the rack rails, then slide the unit fully into the rack (see
Latches
Caution: Be sure to keep the enclosure parallel to the floor when sliding the
component rails into the rack rails. Tilting the enclosure up or down
could damage the rails.
Note: To remove the enclosure from the rack, disconnect the cables from the back
of the unit. Press the latches on each side and pull the enclosure from the
rack (see Figure
4 Tighten the front panel thumbscrews.
5 If used, retract the stabilizing feet of the rack.
6 Plug the AC power cord into the power cord connector, then into a grounded outlet
(see Figure 28).
27).
Installing the 1U Rackmount Enclosure in a Rack
Figure 27).