Quantum LTO-3 Quick Start Manual page 11

Figure 16 Connecting the SAS
and Power Cables (LTO-5 and
LTO-6 Only)
Installing a Second Tape Drive or Replacing a Tape Drive
LTO-3 (Model B), LTO-4 (Model B), LTO-5, and LTO-6
3 For an LTO-5 and LTO-6 SAS tape drive, connect the following cables to the back of
the tape drive (see Figure
a SAS cable
Note: Ensure that a 4-pin Molex power connector is plugged into the power
inputs of the SAS cable as shown in
SAS cable
4-pin Molex power connector
Re-installing the Top Panel
To re-install the top panel (see
1 Install the top access panel on the 1U rackmount enclosure and slide toward the
front of the rackmount enclosure.
2 Secure the latch by pushing it down into the top access panel.
3 Tighten the latch screw to secure the top access panel to the 1U rackmount
enclosure.
16).
Figure 16.
Figure 17):
11