Installing the 1U Rackmount Enclosure in a Rack
Figure 20 Rail Mounting Kit
Components
Tools Required
Installation Procedure
Installing the 1U Rackmount Enclosure in a Rack
LTO-3 (Model B), LTO-4 (Model B), LTO-5, and LTO-6
The rack rails supplied with the 1U rackmount enclosure can be used to install the unit in
racks that have round, square, or threaded holes in the vertical mounting bars. The rails
are identical and may be mounted on either the left or the right side.
Outer rack rails
Inner rack rails
If you are installing the tape enclosure in a rack with unmarked holes in the vertical
mounting bars the following items will make the rack installation easier:
• Pencil
• Tape measure
If you are installing the tape enclosure in a rack with threaded holes in the vertical
mounting bars you will need the following tool:
• 3/16 in. (5mm) flat-blade screwdriver
When installing the enclosure in a rack:
• Start at the bottom of the rack, or at the top of a previously mounted component,
and work upward.
Fasteners
Cable support clips
3
15