Trouble Display - Paradox MAGELLAN MG5000 User Manual

Trouble Display

Your alarm system continuously monitors several trouble conditions that can be reported directly to your
monitoring station. When a trouble condition occurs, the [
keypad will illuminate a number corresponding to the trouble the system is experiencing. Except for the Timer
Loss trouble, contact your monitoring station or installer to resolve the trouble condition.
NOTE: If the keypad emits a
[ ] key to stop the "Trouble Beep".
TBL
Key / LED
Lit
[1]
[2]
[3]
[4]
[5]
Press
[ ]
TBL [6]
[7]
[8]
[9]
[0 (10)]
[16] /
[ ]
SLEEP
6
every 5 seconds whenever a new trouble condition has occurred, press the
BEEP
Accessing the Trouble Display
Trouble Type
Wireless Zone Low Battery
Power Trouble
Bell Trouble
Communication Trouble
Tamper/Zone Wiring Failure
Module Tamper Trouble
Fire Loop Trouble
Timer Loss
Wireless Zone Supervision Loss One or more wireless zones are no longer
Module Supervision Loss
Keypad Fault
] key will illuminate. Press the [
TBL
Trouble Details
The batteries for one of the system's wireless
devices needs to be replaced.
The control panel is experiencing power trouble.
There is a bell disconnect/overload on the control
panel.
Your alarm system, if monitored, could not
communicate with the monitoring station.
A wiring problem is occurring on one or more
devices.
A device's anti-tamper switch has been triggered.
One of the zones is in fire loop trouble.
Your alarm system's clock must be reprogrammed.
See Setting the Time and Date on page 5 to set your
system's time and date.
communicating with the system.
One or more modules are no longer communicating
with the system.
There is a problem with one of your system's
keypads
] key, and the
TBL
User Guide