Trouble Display; Installer Function Keys - Paradox Magellan MG5050 Programming Manual

Trouble Display

- Press the [ ] key to view the Trouble Display. Please note that the keypad can be programmed to emit a beep every 5 seconds
TBL
whenever a new trouble condition has occurred. Press the [
- To view the sub-menu, press the corresponding key in the main menu.
Main Menu Trouble
[1] Wireless zone low battery
[2] Power trouble
[3] Bell trouble
[4] Communication trouble
[5] Tamper and zone wiring failure
[6] Module tamper trouble
[7] Fire loop trouble
[8] Timer loss
[9] Wireless zone supervision loss
[0 (10)] or [10] Module supervision loss
[16] Keypad fault (K32 / K32RF / K32IRF / K32I only)
[17] Upgrade panel to V3.2 or higher (K32IRF only)
[ ] Keypad fault (K636 / K10V/H only)
SLEEP

Installer Function Keys

To access the Installer Function keys, press:
[ ]+[
ENTER INSTALLER CODE
monitoring station.
[ ]+[
ENTER INSTALLER CODE
monitoring station until the next reportable event.
[ ]+[
ENTER INSTALLER CODE
monitoring station that is using the WinLoad software.
[ ]+[
ENTER INSTALLER CODE
(page 39) in order to initiate communication with a computer using the WinLoad software.
[ ]+[
ENTER INSTALLER CODE
will squawk to indicate opened zones. Press the [
Magellan / Spectra SP
] + [ ] = Test Report: Send the "Test Report" report code programmed in section [875] (page 41) to the
MEM
] + [ ] = Cancel Communication: Cancels all communication with the WinLoad software or with the
STAY
] + [ ] = Answer WinLoad Software: Will force the console to answer an incoming call from the
SLEEP
] + [ ] = Call WinLoad Software: Will dial the PC telephone number programmed in section [915]
BYP
] + [ ] = Installer Test Mode: The installer test mode will allow you to perform walk tests where the siren
TBL
] key again to exit.
TBL
] key to stop the beeping.
TBL
Sub-Menu Trouble Menu
[1] to [32] Zones in low battery
[1] Low/No battery on the control panel
[2] AC failure on control panel
[3] Auxiliary overload on control panel
[4] Wireless keypad AC failure
[5] Wireless keypad battery failure
[6] Wireless repeater AC failure
[7] Wireless repeater battery failure
[1] Bell disconnect on control panel
[2] Bell overload on control panel
[1] Telephone Line Monitoring on control panel
[2] Fail to communicate on Monitoring Telephone 1 on control panel
[3] Fail to communicate on Monitoring Telephone 2 on control panel
[4] N/A
[5] Fail to communicate on voice telephone on control panel
[6] Fail to communicate with PC on control panel
[9] GSM no service (GSM network failure)
[STAY] GSM RF jamming
[1] to [32] Zones in tamper and zone wiring failure
[1] 2WPGM
[2] Keypad bus
[3] ZX8 bus module
[4] RTX3 bus module
[5] Wireless keypad
[1] to [32] Zones in fire loop trouble
[1] to [32] Zones in supervision lost
[ ] RF jamming trouble
STAY
[1] 2WPGM
[2] Keypad bus (Panel reset will not clear this trouble, clear it in
section [955])
[3] ZX8 bus module
[4] RTX3 bus module
[5] Wireless keypad supervision failure
[6] Wireless repeater supervision failure
[7] N/A
[8] VDMP3
[9] GSM module
48