User Operation; Alarm Display; Trouble Display - Paradox Magellan MG5050 EN Reference & Installation Manual

16.1

Alarm Display

If an alarm has occurred on a zone, the respective zone LED will flash, the [
memory. These respective LEDs will continue to flash until disarming even if the zones are restored. To exit this mode and switch
to live display mode before disarming, press the [
the [ ] key remains lit. Press the [
MEM
memory will be erased when the next alarm occurs and after a valid code is entered or upon full-arming the system.
16.2

Trouble Display

Press the [ ] key to view the Trouble Display. Please note that the keypad can be programmed to emit a beep every 5 seconds
TBL
whenever a new trouble condition has occurred. Press the [
To view the sub-menu, press the corresponding key in the main menu.
[1] Wireless zone low battery
[2] Power trouble
[3] Bell trouble
[4] Communication trouble
[5] Tamper and zone wiring failure
[6] Module tamper trouble
[7] Fire loop trouble
[8] Timer loss
[9] Wireless zone supervision loss
[0 (10)] or [10] Module supervision loss
[16] Keypad fault (K32/K32+,K32RF only)
[ ] Keypad fault (K10V/H only)
SLEEP
60
Reference & Installation Manual
Part 16: User Operation
] key to illuminate the LEDs corresponding to the zones that were in alarm. The alarm
MEM
Main Menu Trouble
MEM
] key. Once the system is disarmed, the zones' LEDs will turn off, while
CLEAR
] key to stop the beeping.
TBL
[1] to [32] Zones in low battery
[1] Low/No battery on the control panel
[2] AC failure on control panel
[3] Auxiliary overload on control panel
[4] Wireless keypad AC failure
[5] Wireless keypad battery failure
[6] Wireless repeater AC failure
[7] Wireless repeater battery failure
[1] Bell disconnect on control panel
[2] Bell overload on control panel
[1] Telephone Line Monitoring on control panel
[2] Fail to communicate on Monitoring Telephone 1 on control panel
[3] Fail to communicate on Monitoring Telephone 2 on control panel
[4] Fail to communicate on pager telephone on control panel
[5] Fail to communicate on voice telephone on control panel
[6] Fail to communicate with PC on control panel
[1] to [32] Zones in tamper and zone wiring failure
[1] 2WPGM
[2] Keypad bus
[3] ZX8 Bus Module
[4] RTX3 Bus Module
[5] Wireless keypad
[1] to [32] Zones in fire loop trouble
[1] to [32] Zones in supervision lost6
[ ] RF interference trouble
STAY
[1] 2WPGM
[2] Keypad bus (Panel reset will not clear this trouble, clear it in
section [955])
[3] ZX8 Bus Module
[4] RTX3 Bus Module
[5] Wireless keypad supervision failure
[6] Wireless repeater supervision failure
] key will light up, and the zones will be stored in
Sub-Menu Trouble Menu